|
assuming you used a line up shaft,,if you have it that close turn the output shaft in the tranny..does it act like its engaged[make sure it is in a gear]
if it does it may be just that you have the pressure plate off just a little and will be hard to finish going in
you can install a few screws in the bellhousing and tighten them down to see if it draws it in.
when you have pressure on the bolts[not alot] then try to pull tranny back and forth to loosen up bolts,,,then continue to tighten up more
dont overtighten the bolts and only tighten them slightly to avoid breaking a ear off the bell housing but usually this is harder to do than you would thinbk
i think tho you should re align the plate using the line up shaft ..make sure the line up shaft if centered as you look at the pressure plate opening
hope this helps...if not ,,repost
|
