In restoring my '65 GTO hardtop the drivers side fender bolt inside the door way spun and had to be cut off. I am very open to suggestions on the best way to repair. I have some ideas but don't like any of them.

Hey all. During a clutch replacement we decided to replace the leaky oil pan while in there plus the freeze plug looked suspect. Lifted the motor up some, popped it out and there was a bit of sludge but nothing concerning. However, when we popped the windage tray off look what was in there...

If someone wouldnt mind I am at some point going to convert manual to power steering. I really could use some pictures of the correct position and which bracket & location as well as belts etc. I recently acquired 2 brackets, pump, gearbox, hoses and gearbox, $50. I spent a few hours cleaning...

I have my tri-power carbs off the car and am ready to reinstall the phenolic insulators. While I have them off, I decided that I want to tune the center carb mixture screws without the front carb in place, using block-off plates for the front and rear carbs. This means I need to run a temporary...

Hey guys, read a few post and didn’t see any that fit what I’m encountering. When I start the car and let it idle you can smell gas fumes. Not like straight gas but like possibly running rich. I pulled it out of the drive turned around and backed it up into the carport and my shirt now has a...