Pontiac GTO Forum banner
Showcase cover image for BRZN's 2006 Pontiac GTO

General Information

Brazen Orange Metallic
SAP/SLP 455/Billet Prototypes
Purchased new in May 2007 with 110 miles at A. W. Golden Pontiac Reading, PA.
2006 Pontiac GTO (Brazen Orange Metallic)


Dealer Installed, SLP Bobcat 455HP Performance Package: Long Tube Ceramic Coated Headers (Held in Place w/ARP Stainless Steel Studs and 12-Point Nuts) w/Powerflo-X Crossover/High Flow Cats, Loudmouth II Cat-Back Exhaust System, 1.85 Rocker Arm Package, Harmonic Balancer/Under-Drive Pulley, 160 Degree Thermostat.

Formato Tune: With Both, His Stock Ported Throttle Body and Intake Manifold (Stage 2) w/ARP Fasteners. DynoJet Results: 399.37 RWHP & 382.09 Foot Pounds of Torque. Dyno Pulls Done at Keith's Pit Stop Gettysburg, PA April 20, 2010.

Cold Air Intake (CAI) System: VaraRam VR-SDR Over the Radiator CAI, Underside Insulated with Design Engineering, Inc. 1,500 Degree Cool Tape. Vector Motorsports LS2 Heat Soak Reduction, Intake Air Temperature (IAT), Relocation Kit Installed into the Passenger Side Rear of the VaraRam Air Filter Element. Modified Radiator Air Baffle Cut and Trimmed with Door Edge Guard. Hood Scoop Plugs are Cut to Allow Maximum Air in Through the Pockets While Still being able to, both, Hold the Hood Liner in Place and Keep Dirt from getting within the Hood Scoop Area.

GMM Rip-Shift Street Version Shifter w/Cobra Bob's Silicone Gasket Kit (Thanks to robscar for the Install Assistance!).

Billet Prototypes Complete Billet Aluminum Engine "Dress-Up" Package including his Catch Can and Hose Ends with Black Braided Hose (All Clear Anodized with the Exception of the Strut Tower Caps and A/C Recharge Valve Cap being Black). Billet Aluminum Oil Cap and Tensioner Pulley. Russell Stainless Steel Braided Fuel Line from Hinson Super Cars. Orange Overlays and Black 6.0 Litre Decal on Fuel Rail Covers, "PONTIAC" Sticker on Strut Tower Brace.
Custom Wheelskins Euro Perf Steering Wheel Cover.
JHP Guage Pod.
Bit of Orange on Center Arm Rest to Match Wheel Cover.
Full SAP (Sports Appearance Package) Rear bumper and SAP Mufflers not installed.
Clear Bra.
XM w/Samsung Nexus Portable Receiver/MP3 Player Recorder, Auxiliary Radio Input w/PAC SN1-1/3.5 Minijack Ground Loop Isolator. Stock Sub Woofer Amp Gain Adjusted to MAX.
Wheel and Tire
Depends on My Mood
1.)TSW Laguna 18x8 Wheels and Billet Prototypes TSW Specific Billet Aluminum Hub Rings and Valve Stem Caps, Wrapped w/Y Speed Rated Michelin Pilot Sport 2 245/40ZR 18's all the way around.
2.)A Set of Stock 2004 MC2 FZ6 GTO Wheels usually stored in the Basement, Wrapped with a Set of OEM 235/40ZR 18 Bridgestone Potenza RE040's.
McGard Spline Drive Chrome Lug Nuts and Locks. Chrome sleeved valve stems. Hell, I even have Chromed Plastic Valve Stem Caps with GTO printed on them.

OEM 18" Wheels and Tires Boxed up and Stored Away.



There are no comments to display.