[Scott06]

Attached is a picture of how I intend to drop in the engine/headers

Are you just dropping it on the bare frame? that should work if you remove the crossmember of course depends on where the collector to crossmember fit lands

 

[Scott06]

If butler makes spacers the OP cant be the only one having issues with header fit

 

[Scott06]

All information is helpful. I'll have to wait until Monday to speak with Butler/Ames.

I realized my last video displaying my concern was 9 seconds.

Below I attached a longer version for all to see for theirs an mine future mods.

The engine will hang down without a trans hooked up. I would mock that up before doing and clearancing work

 

[Scott06]

When I did my TKX install, my engine sat unsupported for two weeks and it didnt move. When shimming my trans mount for the drive angle, I hit the extremes of the range of motion.

In the end, it was only the rag joint that hits, and only when the steering is in one position, and the cam's rough idle is making the motor bounce.

Must be the motor mounts used mine drops towards the rear significantly when trans is out