Pontiac GTO Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
25 Posts
Discussion Starter #1
I want to put a new 2.5" exhaust system on my 1967 GTO. I want to use stainless steel. Flow master has a SS system with H-pipe (preferred over X-pipe) but they differentiate between 64-67 and 68-72 model years. I know they say the 64-67 exits behind the rear wheels and 68-72 exits rear, under bumper. I want exit rear, under bumper. Some mail order firms just sell the one kit for 64-72 with rear exit, like I want, but only aluminized steel and I want stainless. My question (finally) is, from the trans crossmember back, is there any other difference in exhaust configuration than exit point, or can I put the "68-72" kit with rear exit on my 67 without any trouble?
 

·
Super Moderator
Joined
·
5,744 Posts
Take a look at the systems offered by Ram Air Restorations. Everything they do is high quality. Case in point: their reproduction RA exhaust manifolds are light years ahead of "everyone elses". They're not going to be the cheapest.

Bear
 
1 - 3 of 3 Posts
Top