[nardulli]

Hey All,
Does anyone have a line on where I can buy / borrow / rent one of these tools? They seem impossible to find.

 

[Goat_Herder]

If you find one or somebody to make one let me know, I need one too. MaverickMan used to sell them but it says he’s out of stock. They can be made too if you have specs. Any weld shop could make one if they have the specs. I’d pay for one.

 

[nardulli]

If anyone has the drawings or detailed dimensions for this tool I'd make a few and we could share them in the forum. My company has a complete fab and CNC machining department.

 

[Goat_Herder]

If anyone has the drawings or detailed dimensions for this tool I'd make a few and we could share them in the forum. My company has a complete fab and CNC machining department.

page5 of manual shows it under car, last page is schematic.

 

[Goat_Herder]

If anyone has the drawings or detailed dimensions for this tool I'd make a few and we could share them in the forum. My company has a complete fab and CNC machining department.

looks like 2x2 and 1x2 bar stock. Have to mic the holes to see what size the pins are. Then make sure there at same angle/length

 

[nardulli]

With this plus the factory workshop manual I can Absolutely make this. As soon as I’m back from vacation I will get going on it. Will gladly loan to the forum members. Or will sell for cost.