Pontiac GTO Forum banner

1 - 9 of 9 Posts

·
Registered
Joined
·
1,612 Posts
Looks like the Dyno shop here in NorCal., same set-up, small bays and website. Did a great job on the tune, but the kids in the back doing the Mods. will never touch my car again, they sucked. Install of both Mods. were not done right, nothing that I could not fix, but not cool at all. This was my deal, hope yours are better...:cool
 

·
Registered
Joined
·
10 Posts
Discussion Starter #3 (Edited)
With just a couple of bolt on mods I gained 45.1 hp and 37.9 ftlb torque. The guy that owns the place name is Kushan. He does all of the work himself.

With a Volant intake, and Magnaflow mufflers with an X-pipe. I am getting 315.6 hp and 340.7 ftlb of torque. On another Dyno I got 342.1 hp and 358.1 ftlb torque.

After the first of the year, I plan on adding FAST intake, cam, heads, throttle body, and headers. Not sure how much of an increase I will get, but Kushan will be doing all the work himself.

This guy has been doing Vettes for a long time and since the guts are the same, I put my trust in him to do the best job.
 

·
Registered
Joined
·
1,612 Posts
With just a couple of bolt on mods I gained 45.1 hp and 37.9 ftlb torque. The guy that owns the place name is Kushan. He does all of the work himself.

With a Volant intake, and Magnaflow mufflers with an X-pipe. I am getting 315.6 hp and 340.7 ftlb of torque. On another Dyno I got 342.1 hp and 358.1 ftlb torque.

After the first of the year, I plan on adding FAST intake, cam, heads, throttle body, and headers. Not sure how much of an increase I will get, but Kushan will be doing all the work himself.

This guy has been doing Vettes for a long time and since the guts are the same, I put my trust in him to to the best job.

Sounds like you found a winner, good job...:D
 

·
Registered
Joined
·
76 Posts
With just a couple of bolt on mods I gained 45.1 hp and 37.9 ftlb torque. The guy that owns the place name is Kushan. He does all of the work himself.

With a Volant intake, and Magnaflow mufflers with an X-pipe. I am getting 315.6 hp and 340.7 ftlb of torque. On another Dyno I got 342.1 hp and 358.1 ftlb torque.

After the first of the year, I plan on adding FAST intake, cam, heads, throttle body, and headers. Not sure how much of an increase I will get, but Kushan will be doing all the work himself.

This guy has been doing Vettes for a long time and since the guts are the same, I put my trust in him to do the best job.
Where is this guy at? I need someone to do my cam swap.
 

·
1/8 7.63 at 89.14, 60ft of 1.61
Joined
·
260 Posts
Where is this guy at? I need someone to do my cam swap.
You could also try Don Lee Auto Service,9793 Foothill, Cucamonga,Ca., 909-989-1573
He installed my gears, and I know of other people who have had engine work done by him. Does good work.
 
1 - 9 of 9 Posts
Top