I just acquired a 1967 GTO that has gone through a reasonable restoration, but there are some minor things I still need to do. Can anyone suggest a good service manual(s), either printed or on CD?
1964-1974 Tempest, Lemans & GTO General Discussion
I'm getting ready to purchase a clutch and pressure plate for my 69 Judge. The engine is a mostly stock ram air 3, other than the hydraulic roller cam. My flywheel is the 166 tooth one, approximately 13-5/16 in diameter and the transmission has the 10 spline input shaft. It's a restoration and...
1964-1974 Tempest, Lemans & GTO General Discussion
I am readying my engine for paint. One bolt unfortunately broke and whats left of the bolt wont budge. We have soaked it in PB blaster, heated it, welded nuts to it....just wont budge.
I am installing Ram Air manifolds.....it is the forward left exhaust port...right bolt. If we just cut it...
1964-1974 Tempest, Lemans & GTO General Discussion
Hello Forum....I am new to this forum. I recently purchased a 1968 GTO convertible. I feel pretty lucky that I was able to get it. The caris in kinda rough shape....needs a lot of TLC.
Here is a picture or two...
1964-1974 Tempest, Lemans & GTO General Discussion
Just stumbled on this little device. Did some quick searching and have yet to find a bad review. Anyone running or tried one of these on their carburetors? Suppose to make your shot of fuel atomize better.
https://thompsonperformance.com/
A forum community dedicated to Pontiac GTO owners and enthusiasts. Come join the discussion about performance, modifications, troubleshooting, maintenance, history, and more!